Latency & Jitter Test Options#

../../_images/latency_panel.png

Fig. 23 Latency & jitter test options#

Common Options#

  • Duration Type

    Defines how to control the test duration, either by time or by frame count.

  • Duration

    The duration of each test trial.

  • Iterations

    The number of times to repeat each test trial with the same set of test parameters.

Rate Sweep Options#

  • Start Rate

    The starting rate in percent of the port rate used by the rate sweep.

  • End Rate

    The ending rate in percent of the port rate used by the rate sweep.

  • Step Rate

    The increments in rate percent for each step in the rate sweep.

Misc. Options#

  • Latency Mode

    The latency mode used when measuring the latency.

  • Relative to Throughput

    If checked the starting and ending rates will be calculated relative to the result from a preceding throughput test for the same frame size. If the throughput test has not been performed in the same test this setting is ignored. If the throughput test has not been performed in the same test this setting is ignored.