4.1. Summary

Management Command Summary

Command	Description	Example
connect	Connect to tester	connect 10.10.10.10 yourname
port	Reserve and switch port	port 0/0 | port 0/0 --reset
ports	List ports	ports | ports --all
module-config	Set module media and port config	module-config 0 osfp800 8 100g
exit	Exit the session	exit

AN/LT Command Summary

Command	Description	Example
anlt start	Apply and start AN/LT on the port	anlt start
anlt stop	Stop AN/LT on the port	anlt stop
anlt log	Show AN/LT protocol trace log and save to a file	anlt log --filename mylog.log
anlt log	Read saved log file	anlt log --read -f saved_mylog.log
anlt autorestart	Control AN/LT autorestart	anlt autorestart --link-down --lt-fail
anlt status	Show AN/LT status of the local port	anlt status
anlt strict	Enable/disable ANLt strict mode	anlt strict --on
anlt logctrl	Control what should be logged in AN/LT by xenaserver	anlt logctrl

AN Command Summary

Command	Description	Example
an config	Configure AN of the local port	an config --on --loopback
an status	Show AN status of the local port	an status

LT Command Summary

Command	Description	Example
lt config	Configure LT of the local port	lt config --on --mode auto --preset0 ieee --timeout enable
lt encoding	Request remote port to use the specified encoding on the specified serdes	lt encoding 0 pam4
lt preset	Request remote port to use the preset of the specified serdes	lt preset 0 2
lt inc	Request remote port to increase (+) its emphasis value by 1	lt inc 0 main
lt dec	Request remote port to decrease (-) its emphasis value by 1	lt dec 0 main
lt status	Show the link training status of the specified serdes of the local port	lt status 0
lt trained	Announce that the specified serdes is trained	lt trained 0
lt no-eq	Request remote port to turn off equalizer on its emphasis	lt no-eq 0 main
lt im	Set initial modulation for the specified serdes of the local port	lt im 0 nrz
lt alg	Set the link training algorithm for the specified serdes	lt alg 0 alg0
lt txtapget	Read the tap values of the specified serdes of the local port	lt txtapget 0
lt txtapset	Write the tap values of the specified serdes of the local port	lt txtapset 0 1 3 4 60 1
lt txtap-autotune	Auto tune the tap values of the specified serdes of the local port	lt txtap-autotune 0