Latency & Jitter Test Options#
![../../_images/latency_panel.png](../../_images/latency_panel.png)
Fig. 23 Latency & jitter test options#
Common Options#
Duration Type
Defines how to control the test duration, either by time or by frame count.
Duration
The duration of each test trial.
Iterations
The number of times to repeat each test trial with the same set of test parameters.
Rate Sweep Options#
Start Rate
The starting rate in percent of the port rate used by the rate sweep.
End Rate
The ending rate in percent of the port rate used by the rate sweep.
Step Rate
The increments in rate percent for each step in the rate sweep.
Misc. Options#
Latency Mode
The latency mode used when measuring the latency.
Relative to Throughput
If checked the starting and ending rates will be calculated relative to the result from a preceding throughput test for the same frame size. If the throughput test has not been performed in the same test this setting is ignored. If the throughput test has not been performed in the same test this setting is ignored.