Xena OpenAutomation CLI Command Logo

Table of Contents

  • 1. Introduction
  • 2. Basics
  • 3. CLI Reference
    • 3.1. Chassis
    • 3.2. Module
    • 3.3. Port
      • 3.3.1. General
      • 3.3.2. Traffic Generation
        • Speed
        • TX Control
        • Transmission Profile
        • Loopback Mode
        • Latency Mode
        • MAC Control
        • PFC
        • Payload
        • IPv4
        • IPv6
        • Multicast
        • Histogram
        • Filter
        • Capture
        • Error Handling
        • Stream
          • Control
          • Identification
          • TX Profile
          • Connectivity Check
          • Error Injection
          • Protocol Segment
          • Packet Content
            • PS_AUTOADJUST
            • PS_CDFCOUNT
            • PS_CDFDATA
            • PS_CDFOFFSET
            • PS_EXTPAYLOAD
            • PS_OPTIONS
            • PS_PACKETLENGTH
            • PS_PAYLOAD
          • Modifier
          • Config
          • PFC
        • Statistics
        • Runt
        • Unavailable Time
      • 3.3.3. Layer-1
      • 3.3.4. Impairment
      • 3.3.5. Config
      • 3.3.6. Full Config
    • 3.4. Misc
    • 3.5. Special
  • 4. Glossary of Terms
Xena OpenAutomation CLI Command
  • 3. CLI Reference
  • 3.3. Port
  • 3.3.2. Traffic Generation
  • Stream
  • Packet Content

Packet Content

  • PS_AUTOADJUST
  • PS_CDFCOUNT
  • PS_CDFDATA
  • PS_CDFOFFSET
  • PS_EXTPAYLOAD
  • PS_OPTIONS
  • PS_PACKETLENGTH
  • PS_PAYLOAD
Previous Next

© Copyright 2025, Teledyne LeCroy Xena.